Add Wrap

The difference between Cut size and Finish size arise due to Centre joints (center heat sealing) and border folds (border hem). The Cut size is a gross measurement of fabric before any fabrication. Each joint and border fold would consume 5 to 7 cm. The Finished size is a net available measurement of the tarp after all the fabrication. Hence, the cut size is bigger than the Finish size.

A larger size will have a higher number of center joints and hence it will result in a higher difference between the Cut size and Finish size.

Available Finished size will also depend on the width of the fabric to be consumed to produce a given size.

During process of making tarpaulin, few accessories are added i.e. border rope, eyelets / grommet, liner bag etc. These accessories create difference in weight of the fabric and weight of ready tarpaulin piece made from the same fabric. The smaller the size of tarpaulin, the bigger will be the difference between weight / GSM of fabric and ready Tarpaulin.

We only offer products based on Fabric weight / GSM.

Ultra Violet rays have a negative effect on plastic. UV breaks down the chemical bond of the polymer which results in the degradation of plastic. Physical and noticeable characteristics are reduced strength, color brightness, elongation also it will start cracking and chalking.

The solar UV radiation is measured in kilo Langley (kly) per year. Depending on the exposure to radiation, UV stabilizers must be added to reduce the degrading effect.

Core Diameter (O.D.)*

Material Thickness*

Roll Length*

Estimated Roll Diameter

Estimated Roll Diameter

Cut Size and Finished Size

Weight / GSM of Fabrics And Ready Tarpaulin

UV Stabilization

Core Diameter (O.D.)*

Material Thickness*

Roll Length*

Estimated Roll Diameter

Estimated Roll Diameter